Tiêu đề Giá đỡ IKEA Skadis dành cho đầu hàn ruthex cho các miến

These are small holders for the ruthex soldering tips for heat insets. There are six versions:

• double row holder with hook
• double row holder with hook and text
• double row holder prepared for T-Nut
• double row holder prepared for T-Nut with text
• single row holder with hook
• single row holder with hook and text

For the T-Nut-system from 6d6178 (M3 screw) you need T-Nuts. They can be found at the T-Nut-System from 6d6178 or you use other T-Nuts like e.g. the ones i designed (T-Nuts).

As i also needed some trays for the insets i made some with hooks respectively with preparation for the T-Nut system. There are trays with 4, 6 or 8 compartments, the trays are 80mm wide. You may use the trays for other things like little screws.

Printing:

• PLA or PETG, any other material should work fine
• 3 Perimeters
• i used 15% infill
• for the hook versions i used a brim (only were the hook hits the bed), for the T-Nut version no supports are required
• Layer height: as you like, i used adaptive layer height in the slicer and it worked perfect