Honeycomb utility drawer

I needed drawers for printer stuff under my printer base plate. This drawers are screwed under e.g. wooden surface and can be aligned horizontally with a bunch of other drawers sharing a rail (see drawing). I choose to have a more open drawer bottom, so small stuff like printer debris can fall through and did not dirty it.

Drawers can be fully pull out, so pay attention that you didn't accidentally pull it out completely.

If you want have a end stop, so you can't push it through, just use at least one mid rail, because that has the “pull through” protection.

Print instructions:

no special instructions here, do as you like. I used variable layer heights to get smooth roundings

I used Prusament PLA royal blue and galaxy silver.

See also my other workshop stuff: https://www.printables.com/@Antimaterie/collections/1000059

additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes. If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.