Tiêu đề Kẹp giữ Cleat của Pháp Tóm tắt Kẹp giữ kìm Cleat c

This is a simple but effective holder for pliers and other stuff that you can hang onto a rod for your french cleat wall.

Additional Parts:

• 12,5 cm M5 threaded rod

Print instructions:

• print in orientation shown in picture.
• 3 or more perimeters
• at least 15% cubic infill
• PLA is ok, I used Prusament royal blue PLA

Assembly:

screw the rod through the hole until it is fully flush. You can predrill the threads with an M5 screw if desired.

See also my other workshop stuff: https://www.printables.com/@Antimaterie/collections/1000059

additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes. If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.