Tiêu đề Vòng cáp ren tham số dành cho phụ kiện E27 Tóm tắt Th

Threaded Cable Grommet for the E27 fitting

Appropriate for round or flat flexible cables, configured by default for European E27 fittings with a M10x1 thread. The default stl exports will fit a generic flat 2x0.75 mm2 cable. You can customize the model in OpenSCAD Customizer if you have different requirements.

Printing guidelines

• Setup OpenSCAD (if you would like to adjust the model)
  • Install the threadlib library
  • Optionally modify the project in the OpenSCAD Customizer
  • Export the stl file
• No supports are needed
• Print in PETG with a 100% rectilinear infill using the 0.05 mm or 0.07 mm ULTRADETAIL settings
• Use the "Avoid crossing perimeters" setting in the eSlicer (so you can make sure the cable grommet does not get obstructed).