Tiêu đề Huy chương treo tường Tóm tắt Giá treo tường đơn gi

Summary

Simple wall mounts that I made for either a 4.5" or 6" medallion. Holds the medallion at a 5 degree angle when mounted to the wall and also includes a spot to clip a lanyard below the medallion for display purposes.

Print Settings

The print settings you use are mostly irrelevant however since the top surface is angled I would suggest printing at a small layer height or by using adaptive layer heights to minimize the “stair stepping” effect on the top surface. My print settings were as follows.

Layer Height: 0.2mm

Wall Loops: 3

Infill Density: 15%

Infill Type: Gyroid

Supports: yes (needed for lanyard loop)

Material: PLA