Spartan Trifecta Wedge Medal Holder (2023)

File Selection

I've broken model into 2 different pieces so it can be a dual color if desired:

1. “1a_trifecta_wedge_2023_main_body.stl”
2. “1b_trifecta_wedge_2023_text.stl”

To line up everything, just highlight both models in eSlicer, right click, then “merge”. The font should find the correct location relative to the main model when you do.

OR

Alternately you can use the “2_trifecta_wedge_2023_complete.stl” if you only want to print one color.

Print Instructions

Once you've selected your model, I found it was best to lay it flat on the bed.

Its simplest to use the rotate menu in eSlicer: just attempt to lay it somewhat flat, then use the “lay flat” button in the rotate menu. I printed with a Creator Pro 2. One I laid it flat, I had to rotate it about 30 degrees a bit to get a good fit on the Y axis of the bed.

Print with whatever resolution you want, no supports needed. I did .1mm layers, but really it would have been fine with .2 or maybe even higher.

Enjoy, and congrats on earning your 2023 Spartan Trifecta Wedges. AROO! AROO! AROO!