Tiêu đề Giá đỡ máy ảnh Kobra 2 Tóm tắt Đây là bản phối l
Đây là một bản phối lại cho giá treo máy ảnh khớp nối Sneaks để phù hợp với trục Z của Kobra 2 Anycubic.
3.2K
Lượt Xem
22
Lượt Thích
129
Lượt Tải
Cập Nhật Nov 22, 2025
Mô tả
A bracket to use the articulating pi camera mount on the Anycubic Kobra 2. This should work with the Kobra 2 Pro/Max/Plus not the neo.
You will need 2 m3x12 bolts to mount this.
Print with 100% infill
PLA is fine but wont hold up in a chamber.
This mounts to the back of the z gantry carriage.
- Loosen the z-axis belt.
- Remove the two bolts that hold the belt tensioner cover.
- Use two M3x12mm to install the mount onto the back side of the z axis carriage.
Giấy phép
Model files
Loading files, please wait...