Tiêu đề Ender-3 PSU Mount Dual Z Offset Tóm tắt Giá đỡ bù bên

Quickly designed this basic mount because I wasn't finding anything that was simple and didn't require me to reroute the wires after upgrading to belt driven Z axis.

PSU is mounted at the extrusion's height allowing the XT60 connector to slip underneath or around it without any modification required.

I printed at 0.2mm and 100% infill. Mysterious Abyss PETG

The original M4 screws that came with the power supply were too short. I ended up using 2x M4-12mm screws with TPU washers (to reduce length and vibration). 2x M5-8mm and T-Nuts for the mounting to the 4040 extrusion.

I would recommend attaching a separate ground wire from the PSU to the printer's frame, just for extra safety.