Tiêu đề Bộ phụ kiện Elegoo Neptune 3 ProPlusMax CW2 Voron StealthBu

A total re-design of my bowden version which was a remix this model was designed from scratch using the same dimensions but cutting out more material for clearance. I've also added a heatset hole in the side for the original neptune inductive probe.

Probe location is 2(ish)mm higher than where the nozzle should land.

Update, Version 8: Dropped the whole thing 8mm as V7 wouldn't reach the bed if hard mounted, also fixed probe location to prevent interference with the backing plate.

Update, Version 9: This is the final iteration used on my machine, it spaces the printhead far enough forward to allow the use of pan/cap head screws to fit to the original carriage and also moves the probe forward 2mm.

Printing: Printed in PLA for Prototyping, ABS Reccomended. .2 Layer Height No Supports Needed 40% Infill 4 Walls, 4 Top & Bottom Layers

Parts Needed: Stealth Burner Toolhead + Screws for fitting. 7x M3 Heatset Inserts 3x M3x18mm Screws 3x M3 Nuts (Nyloc reccomended) 1x M3x10mm Screw (Probe)

Klipper Config: Probe Offsets: x_offset: -29.3 y_offset: 32.37