Vase Mode Water Cracker Jar

Perfectly sized to keep your crackers fresh.

This is sixed to hold the standard water crackers packet of 70x200mm
it fits inside with or without its wrapper and keeps the crackers fresh and unbroken in the cupboard.
I was getting fed up of having to twist up the wrapper or put clingfilm around it etc

The lid is a quarter turn thread so comes on and off quite easily,
The thread pattern covers the whole body to stiffen the tube and add a little protection for the crackers as well as looking nice.

print instructions
The main body is to be printed in vase mode 0.6 extrusion width
set minimum bottom layers to make a base 1mm thick
once printed deburr/sand the top rim for smoothness

The Lid is printed on normal settings

i have also designed a vase mode lid which fits the motif of the rest of the design better,
and works perfectly well, but i think on balance the normal lid is superior.