T-Hunt MK4 Sniffer Case

This is a case I designed for the VK3YNG MK4 transmitter hunting sniffer made in Australia. It's designed to fit on the end of 1/2" PVC pipe. Holes for screws are included to hold PVC pipe and make it easy to disassemble or modify location.

Print 100% infill for lots of strength. I used support everywhere.

Use adhesive Velcro dots to help keep the sniffer in place.

New gen 2 enclosure parts added 8/30/2020. For gen 2 you need to print the PVC mount base part and either the protective cover for when the sniffer is not in use. Or, the somewhat protective case where the sniffer is protected on the sides while in use.You don't need both. I broke the old style into two pieces so I didn't have to use support. I really do not like to clean out support. I'm sure you will figure it out.

73,

WA6ED

Category: Electronics