Tiêu đề Bộ điều hợp gắn góc nghiêng SVS Atmos Tóm tắt Khi

Used to angle SVS Elevation speakers towards the ear level of the listener and uses the existing mount provided by SVS.

Files included are for a 34.7 degree angle, which was for my personal setup. However the included fusion 360 file is parametric and the angle can be easily changed. You will also need the “washers” to help make a level surface for the screws.

To assemble: Push the existing SVS metal bracket onto the angled mount, put the washers on top (T - goes to the top, B goes to the bottom) and ensure the thickest part faced towards the listener (to create a level surface). Run your bolts or screws through that.

NOTE

Specialty screws are needed to bolt in the back, I used 5inch (10-24) machine screws as these were fastened by toggle bolts. Depending on the angle needed you may need larger, 6 inches was the largest screw I could find locally.

---

Printed on a Bambu X1C

Material: PLA Tough

Nozzle: 0.2mm

Setting: (Strength)

Supports: None