Tiêu đề Prusa XL series Hỗ trợ dẫn hướng PTFE Tóm tắt Tôi g
Tôi đã gặp rất nhiều rắc rối chèn dây tóc trên ống PTFE vì nó luôn bị kẹt trong máy đùn. Không còn nữa!
Mô tả
I had a lot of trouble inserting filament over the PTFE tube because it allways get stuck an the Extruder. Not anymore ! My adapter helps to straighten the last 2 cm of the ptfe tube to the Extruder. This helpfs to guide the Filament in a straight way.
Please print as fine as possible, i used a 0.25mm nozzle with an (overkill) 0,05mm layer height
Have fun!
After many asked me how they could support me, you can now
Tip me on KO-FI by klicking here:
https://ko-fi.com/surfalex2000
Check out my other optimized XL Parts! There is a Series to come!
You can find them in my Collection: https://www.printables.com/@Surfalex2000/collections/830114
Giấy phép
Tác phẩm này được cấp phép theo
Creative Commons Attribution-NonCommercial 4.0 InternationalAttribution-NonCommercial
