Tiêu đề Durston Z-Flick Tent Pole cải tiến cho lanshan 2 lều chuyên

Just print the top part with 30% infill. It snap fit on the pole.

The bottom part is not tested yet with the tent. The goal was to fasten the plastic part to the tent, then when stending up the tent the pole just need to push into that bottom part. It does not allow the bottom part of the tent to move up when using the zipper with one hand.

The mushroom design is based on Jen Yates work from thingieverse. Mostly the hole size is adjusted to durston pole.

The bottom part is not tested in real life usage yet, but it is an original creation.