Tiêu đề Nẹp gắn vào khớp TrackIR 5 TrackClip Pro Twist Tóm tắt

A snap-on brace for the twisting joint of a TrackIR 5 TrackClip Pro antler.

I printed this with PLA, 0.4mm nozzle and 0.15mm layer height. The snap-on profiles on this tiny piece require accuracy to work properly, so try to use the most accurate printing profile you can.

To assemble:

1. Align the antler twist-joint (with the O-ring) in its intended orientation,
2. place both sides of the brace around the joint,
3. squeeze until the two sized snap together. You're done.