Tiêu đề Vỏ SSD Samsung T5 Tóm tắt Thiết kế vỏ TPU giúp bảo

I have created a case for my Samsung T5 SSD that I carry around at work. It is a very clean, snug design and provides support to the USB-C cable to prevent damage when leaving the cable plugged into the drive. I printed this with Overture 95A TPU, but any 95A and softer filament should work. The hole for the cable was designed for the data cable below. I have found similar cables laying around the office, so I assume it is a rather generic USB-C cable, however, just in case, here is a link:

(They sell variable sizes which could be handy for some. )

Some additional strength settings that I used when printing this so that you can get a similar fit are as follows:

Walls: 2

Infill: Cubic

Infill Density: 10%

Supports (Optional): I printed with supports generated inside the model with the USB-C port facing up. Supports were relatively easy for me to remove, however, they aren't necessary and it will likely print fine without them. These settings although rather low, give the print quite a rigid build. however any more strength and it may be too difficult to get into the case. but feel free to experiment yourself. I find that with these settings it is a good balance of strength and cushion for your drive. Installation:

This case is a tight fit so that the drive doesn't rattle around within the case, however, that also means it is rather hard to get into the case. I recommend putting both corners of the port side into the case first, then put one of the top corners in. The last corner will be very tight to get on. but if you use similar settings with similar hardness filament, you should be able to slip the last edge over the drive with enough strength. If you have any modifications/requests, please leave them in the comments. I am more than happy to make changes for others.