Tiêu đề Chauvet Tripod Stand Knob chèn Khối căng Tóm tắt Re-engine
RE KIỂM TRA HOÀN THÀNH BLOCK CỨNG CỦA TÔI cho núm trên cùng. Được sử dụng với Gigbar Chauvet Gigbar 2 Chân máy khóa chân đế
Mô tả
Gigbar2 by Chauvet comes with a tripod. The tension block fell out and I lost it.
Buy the original Part: PTJ5010230030TK - Knob insert block for the Top Knob
About the magnets: Designed in two spots for 3x2mm Round Neodymium Disc Magnets. - Holes are 4mm deep for double stacked, but 1 pressed in good enough for me. You can glue in and fill the clamp hole above the bolt with the magnets, as well as press fit into this print. - The tension bolt and the magnet connect - The magnets (5) in the premade hole above the bolt in the clamp and to the upper magnet in the print connect. (more magnets stuffed into the hole makes it stronger.
Magnets I used: https://amzn.to/43V7Q2b (canada)
Printed in Low quality, 0.28mm Settings 3 walls or more Infill was set to 50% and I didn't hear it crack when I applied good pressure.
Giấy phép
