Tiêu đề Giá đỡ ống chỉ kiểu CrealityEnder3 Tóm tắt Bản sa
Bản sao không biết xấu hổ (nhưng không giống hệt nhau) của giá đỡ cho người giữ ống dẫn đi với Ender 3.
Mô tả
I devised my own spool roller setup and needed a second bracket. I don't know if there are others like this (probably, I never looked) but I decided to make my own for the practice.
Included is a Shim. This shim is for raising the original bracket to the same height as this one. Being plastic and not aluminum I had to beef it up a skosh which resulted in it being slightly taller.
If you use two of the brackets together then the shim is not needed.
Print in the orientation it loads. For strength I printed with 4 perimeters/walls & 100% infill. Other than that there aren't any real setting specific things. Just use what works for you.
First picture shows my bracket. The second photo shows the stock bracket with the shim.
Giấy phép
