Tiêu đề Bìa Merkur 34c Tóm tắt Tôi đang tìm vỏ bọc lưỡi dao

I was looking for a blade cover for my Merkur 34c safety razor and what I found was:

• Expensive.
• Flimsy and not really practical.
• Really well built but annoying for an every day use (travel cover hard to remove).

So I designed 2 covers that fit nicely but not too tightly to avoid trapping water inside the cover as much as possible.

The cover with clip uses the pin of the upper part of the blade holder to stay in place.

The cover with pins uses the border of the bottom part of the blade holder to stay in place.

Print Settings

Printer:

CR-10 V3

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2 mm

Infill:

20 %

Filament:

DAS FILAMENT PLA

Notes:

Only the cover with clip needs support.