Tiêu đề Hệ thống chi tiết có tổ chức theo mô-đun lý tưởng

A system of modular organizers for spray & squeeze bottles, brushes, and other goods common in a detailing shop. Using equally spaced tapered dovetails, these organizers are secure and have low tolerance requirements. Recommended to print in PETG, but other temp and impact resistant filaments should be fine. PLA cannot be trusted to not warp in a hot garage and cause a mess.

IMODS consists of the following components as of 11/11/23:

• dovetailMount: Mounting plate with 2 mounting slots. Use pan-head screws. Print flat on its back.
• dovetailBottleHanger: Holds most 3" or smaller squeeze bottles in an upside-down position, with a hook for spray bottles. Print this rightside up with no supports.
• dovetailBrushHanger: A basic hanger for detailing brushes. Print this upside down with no supports.
• dovetailCup: A basic cup for whatever - pens, swabs, skewers, brushes, etc. Print upside down with no supports.
• dovetailBin: A two-position wide bin. Print upright with >65 degree supports touching buildplate only for the mounting rails. Having one of these can be useful when installing the mounting plates to ensure plates are lined up.
• dovetailHanger: A single-hook utility hanger. Use for tape, tools and more. Print upside-down with >65 degree supports touching buildplate only.