Tiêu đề In tại chỗ Xe sơ tán y tế Stryker M1133 Tóm tắt APC St

Print took almost 38hrs at .2mm layer height %15 infill using 297g of filament on my E5+, although it may take less depending how fast your machine is. I've uploaded 2 versions of this model, the model v2 doesn't have the part protruding out of the passenger side so it can be printed on either side.

I printed it with supports touching build plate, it really only needs supports around the front part. Most of the angles are 45° so the rest shouldn't need too much support. I changed my minimum wall line width in cura to 0.1mm so it can pick up the detail I was hoping for. I used a brim so it wouldn't warp off the build plate, but it kinda caused it to fuse together so it's not as detailed on one side.