Tiêu đề Nespresso Capsule Wall Holder - Single Piece Tóm tắt Remix Nesp

My Nespresso capsule wall holder light by pumikachu were starting to lose their integrity after a few years of hard use. I had also acquired a larger printer since then. I found that Jackierslr had remixed them to be a bit sturdier in Nespresso Capsule Wall Holder.

Design

• I had found the light design a bit flimsy for heavy use, so opted for Jackierslr's remix hoping it would be more sturdy.
• I also did not enjoy the post-print assembly and linkage, specifically on some assemblies the capsules would catch on the middle.
• I had acquired a larger printer since making the original designs by pumikachu, so figured I should be able to print them in a single piece making them stronger again.

Printing

• Will need a 300x300 print bed
  • If your printer is smaller, just go back to the previous iteration by Jackierslr
• I printed in 48mins (acocunting for minimum layer time of 20s) on my v2.4 in ABS

Remixing

• My TinkerCAD design available at this link