Tiêu đề Túi 7 túi ToughBuilt Technician - Large - 3D Print Tool Inserts

I work in a field where I want to make sure none of my tools fall into and are left in the equipment after I am done working on it. I created a insert for my toughbuilt pouch that makes sure all the tools have a proper home, but it also allows me to get them easier and carry more.

The outer screw drivers are tilted slightly, to allow me to fit one more into the pouch.

It “locks” into the pouch with the little bump on the front.

I also have a wera bitcheck holder attached to the side of the pouch. Will give link to that, once I upload it.

Printed at 2mm layer height, and laying on its back with supports.

I am willing to do custom layouts for a fee, just send me a message.

Note: With the weight of the tools I find that the built in clip release latch seems to break on me. It has happened 2 times, and while toughbuilt warrantied it the first time. I was on a job, that i needed it, the second time, so I went and bought a $10 small pouch with the same clip at Lowes, and drilled out the rivets. When I transfered the clip over to my pouch, I used chicago barrel screws, and low profile truss screws, with some mil spec washers to get the best fit.