Tiêu đề Hue Play Bar mount cho Vivo Monitor Pole - KeyFill Desk Light Tó

Works for most vivo monitor poles - allows for vertical or horizontal angles.

You can print two of these to mount two play bars to the same pole (use the second screw hole near the end of the play bar for the second mount).

Use the original hue allen key and screws supplied by Philips manufacturer (check inside your Play Bar manual packaging) to install the Play Bar onto the mount.

There is screw hole and appropriately sized threading for an M3x10mm to M3x14mm screw to tighten strongly to the pole, but it's not required as the print is plenty firm without it. If you do use it, use a tap OR some pressure while screwing to make threads in the plastic.

Printed with using STL or STEP file, with 0.4mm or 0.6mm nozzle with 0.20mm layer heights. PLA or PETG preferred but ABS should work fine (with slight shrinkage). F3D source file supplied for remixing with attribution (non-commercial).