Tiêu đề Nút chặn cửa in tại chỗ có thể gập lại Tóm tắt

Print instructions: Single model print-in-place. Tested with 0.20 and 0.25 layer height.

Setup:

• Pull out the stopper block and put it under the door as desired
• Mark the location where the Plate can fit without stretching the pins
• Use a command strip or any double-sided tape to fix the plate to the door

You could add couple of holes for nails on the plate but I didn't want to punch holes in my door. Feel free to remix the obj file if you choose to

Tip: I personally found 75% scaled down model was enough for my door, saving some material and time