Tiêu đề Hộp đựng giày GoPro Hero Session 45 Tổng hợp Case GoPr

"Print it laying on its back. Raft and supports probably not required but i used them in my final print.

I made this because my mount was too far above the camera and i couldn't find something like this on thingiverse or printables.

Camera should fit snuggly, the cold shoe mount as well. Bend the mount open a bit to get the camera in.

Can't guarantee that it wont slip out though so pls don't sue :)"

-@Jannik_507295

Please check out the original as well.