Tiêu đề Giá đỡ FPV OpenRC F1 Camera WolfWhoop Tóm tắt Giá đỡ

An FPV Camera mount for the OpenRC F1 that was modified to accomidate the WolfWhoop D03 or WT03which are very affordable and often available on the Amazons(at least in the US). This is a modified version of the camera holder Daniel Noree posted on his site so it keeps the same aesthetic as the rest of the build.

It uses an M3x10 countersunk screw and a captive bolt and uses the hole in the lid to mount. You can power the camera from an extra PWM output on your receiver by using a 2 or 3 pin dupont connector and tapping into the ground and 5v pins(use caution you can easily fry the camera's board). Use a dab of hot glue, some sticky tack, or something similar to hold the camera firmly in place if it's a little loose(my WD03 fits tight, my WT03 needs some help staying in). I personally prefer hot glue because it will hold super tight until it gets some ISO alcohol on it then it lets go like Elsa.