Tiêu đề Star Wars Hangar Kệ V2 Tóm tắt Kệ trưng bày nhỏ theo c

Small display shelf inspired by the hangar of an imperial star destroyer from Star Wars. Designed for vase mode.

18cm x 16cm x 10.2cm on the outside, about 17cm x 13cm x 9.6cm on the inside. It barely fits on a prusa mini.

Its sturdy enough, but can not support to much weight. You can stack them vertically and use the connector to align them horizontally side-by-side.

Because its meant for vase mode, it has a lot of slopes, thin parts, and supporting patterns. You can print it without vase mode though. (This would make it stronger, but take more time and filament.)

0.2mm layer height works fine with spiral vase mode. If you are using a file with emblem, you should increase the bottom layer height by 1-2. If you are using a prusa mini, you have to set the number of loops for the skirt to 0 or it wont fit.

Model Tie Fighter and Lambda Shuttle not included.

If you want to support me, you can do so via this link: