Bỏ qua, tới nội dung chính
F3D
Ubiquiti Unifi Protect G3 Instant Outdoor cover 1

3 hình

DIY

Ubiquiti Unifi Protect G3 Instant Outdoor cover

Tác giả mariusbach_1431080

Lượt tải
52
Lượt thích
6
Lượt coi
545

File 3 1,7 MB

  • G3_instant_Cover_Wallmount_1768205660.stlSTL · 421,3 KB
  • G3_instant_Cover_standing_1768205660.stlSTL · 408 KB
  • G3_instant_Cover_bottom_lid_untested_1768205661.stlSTL · 860,8 KB

Tạo biến thể bằng AI

Dựng một phiên bản khác của mẫu này.

Mở Studio

Thông tin

Mã mẫu
#63832
Danh mục
DIY
Ngày đăng
Giấy phép
CC BY — Ghi công

Mô tả

A cover for the G3 Instant for Unifi Protect, to make it a bit more outdoor-durable. No guarantee though, as my own cameras have only been outside for a few days now (including heavy rain, but again, no guarantee).

I recommend putting a bit of tape over the speaker and status led to avoid getting water in. The only remaining hole is for the microphone, which I left open.

Permanent moisture and/or heat/frost may damage your camera - use at your own risk.

Two files - one for standing cameras covering the rear screw hole and one with access to the wallmount screw hole. The third is a bottom lid, which I haven't tested yet.

Printer Brand:

Anycubic

Printer:

All-metal Mega

**Rafts:**

No

Supports:

No

**Resolution:**

0.2

Infill:

100

**Filament:**[any PLA](http://www.amazon.com/s?url=search-alias&field-keywords=any+PLA) fit your needs

Notes:

I used 3 wall lines. Also the fit is tight, you may want to increase x/y-scale by 1-2% if you need.

Category: Electronics

Coi thêm Ẩn bớt

Thông số in

Định dạng
stl
Số file mô hình
3
Tổng dung lượng
1,7 MB
File lớn nhất
860,8 KB

0 bình luận

Coi tất cả