Tiêu đề Giá đỡ PSVR Tóm tắt Giá đỡ PlayStation VR do cá nhân

My personally designed PlayStation VR stand was made with sleek style and functionality in mind. Its tilted headband bracket and forehead rest is positioned at such an angle where when strapped on, the VR sits fairly level and facing straight. There are four countersunk holes in the base for small rubber pads (not necessary for use) that can be glued into them for limited sliding on smooth surfaces. The distance from forehead rest to rear strap bracket is slightly larger than the diameter of the inside headset strap to ensure the VR is held firmly in place when at rest. Made with 30% (thirty percent) infill and 3 (three) shells to prevent cracking when self-threading the screws and room for sanding and painting if so desired. Please enjoy and share my design to spread the word, as this is the only singular stand for PSVR made specifically for display. I hope you enjoy my design and happy printing to all of you!

Special thanks to username: (Neovista49) for uploading the Playstation VR logo which I used as the side decal! Its amazing!

Print Settings

Printer:

Raise N2 Plus

Rafts: