Tiêu đề Tay cầm máy sấy dây tóc Eibos Polyphemus Góc mở rộng

I recently tested out the Eibos Polyphemus filament dryer and made a few replacement parts for it.

The handle included with the unit is two halves held together with a couple of small screws. It is functional but it feels a little flimsy. This is not a 1:1 of it but it is pretty close in a unibody design. I like the single piece much better.

Also, the corner pieces for my expansion kit where incorrectly sized. This meant I couldn't use the included screws and it didn't sit flush. I scanned the profile of the part then extruded it to be a few mm shorter so that it works as intended.

Both where printed out of PETG but this is not a requirement.