Original Xbox 1.0-1.4 spacers.

I found a near perfect original Xbox shell to replace the heavily scratched/rusted case for my 1.0 MB Xbox. these spacer allow you to tighten the screws on each side of the video out connector. these will make it easier to transfer good working MB's into the newer special edition cases designed for the 1.6 boards. I printed 4 at a layer height of .12mm in less time than it took to heat the bed and nozzle on the printer. scaling up or down by a small percentage may be required depending on the accuracy of your printer. this is an update to a model I published on another 3d printing site.