Skip to main content
F3D
Đua Xe Ngón Tay "Finger Racers" 1

2 images

Xe Cộ - Máy Móc

Đua Xe Ngón Tay "Finger Racers"

By ishikawats_866462

Downloads
216
Likes
91
Views
1,185
Remixes
1

Files 2 1.7 MB

  • finger-racer_0.4n_0.2mm_PLA_MINIIS_29m_1765448864.bgcodeBGCODE · 1.2 MB
  • finger-racer_1765448852.stlSTL · 557.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

This is a little racing toy for fingertips:

  • The model is oriented for easy printing. No supports should be needed. Plain bearing is print-in-place.
  • The “pedals” are printed as one piece but breaks apart for press-fitting into the wheel hub. Clean up with a side-cutter if needed. The press-fit can be a bit tight, carefully use pliers if finger strength is not enough.
  • The wheel needs a “tire” for more friction. I cut loops from an old bicycle inner tube. An easy alternative is to just wrap around with some duct tape or electrical tape, or use a broad rubber band.
    • It can be used without the tire but then works best where it is not too slippery, like carpets, vinyl or painted surfaces.

Read more Show less

Print spec

Formats
bgcodestl
Model files
2
Total size
1.7 MB
Largest file
1.2 MB

0 comments

See all