Tay Quay Fidget (Cần Vòng Bi 608)

Basic fidget spinner modeled after a rotary phone dial. Requires 608 bearing.

I've seen some files for printed bearings but I just got a pack from Amazon.

This simple design made for my practice both designing and printing. This is my first design.

Feedback is appreciated. 

Important Print Settings:

• .2 mm Layer Height (likely not critical - choice based on appearance/print time mostly)
• 20% infill (higher infill may give better weight and spin as a result)
• Wall ordering outside to inside (to maintain tolerances for the bearing and cap fits)
• Walls before infill (same reason as above)

Note: If the bearing feels slow - remove the plastic dust / grease covers carefully and spray WD-40 on the bearing to clean out the OEM grease. I'd recommend doing this prior to putting the bearing into the print. If you notice the bearing in my picture has the cover removed - that is why.