
Hộp Đựng & Đế Đứng Danh Thiếp (in-place, không support)
- Downloads
- 1,154
- Likes
- 191
- Views
- 3,535
- Remixes
- 1
- Comments
- 0
Files 3 1.8 MB
- Card_Holder_Stand_108x68x12_0.2mm_PETG_MK3S_3h11m_1765626906.gcodeGCODE · 1.5 MB
- Card_Holder_Stand_108x68x12_1765626904.stlSTL · 135.5 KB
- Card_Holder_Stand_104x68x12_1765626905.stlSTL · 134.4 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #96052
- Category
- Đồ Gia Dụng
- Published
Description
I really appreciate you if you can consider a coffee for me if you like the design!
A business card stand for an exhibition booth or an event table. It folds and snaps as a card holder. It is light, you can carry it as your pocket business card case carry for your everyday use as well.
You can print it as print-in-place with no-support.
I personally recommend using PETG for the heat resistance and durability, however PLA/PLA+/Tough PLA should work as well.
It holds both US business card size as well as Japanese business card size. Slightly narrower size uploaded.
Design
- Print-in-place
- No support
- Light weight
Size
- 108mm x 68mm x 12mm (outer) / 100mm x 61.2mm (inner)
- 104mm x 68mm x 12mm (outer) / 96mm x 61.2mm (inner)
- PETG recommended
- My print settings: 0.2mm layer height / 2 perimeters / 10% infill rectilinier
- Multi-color filament gives a nice gradation finish
- Twist horizontally on the bed depending on your cooling air flow direction of your printer
Thank you!
I would really appreciate you if you can support me !!!
Print spec
- Formats
- gcodestl
- Model files
- 3
- Total size
- 1.8 MB
- Largest file
- 1.5 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-



