Skip to main content
F3D
Di dời vị trí cọc bình ắc quy xe máy 1
Di dời vị trí cọc bình ắc quy xe máy 1
1 / 3

3 images

DIY

Di dời vị trí cọc bình ắc quy xe máy

By Gixxer

Downloads
15
Likes
4
Views
286
Download all (.zip)· 6 files · 2.7 MB· 2.7 MB

Files 6 2.7 MB

  • ring_terminal_base_1765622986.stepSTEP · 78.7 KB
  • ring_terminal_cap_1765622987.stepSTEP · 93.2 KB
  • ring_terminal_base_1_1765622987.3mf3MF · 164.6 KB
  • ring_terminal_cap_1765622988.stlSTL · 1.3 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#95678
Category
DIY
Published

Description

My motorcycles battery is located under the seat and requires tools and time to access. If you find yourself with a dead battery out and about it's a difficult and time consuming problem. So I designed a insulating housing that snaps on the rear subframe in the trunk. There are notches in case you want to use zip ties but i havent needed them. It holds one #10 ring terminal captive. You just pull off the cover and take out the ring terminal to connect your charger or jump pack to. Easy no tools just your key.

Read more Show less

Print spec

Formats
3mfstepstl
Model files
6
Total size
2.7 MB
Largest file
1.3 MB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy