Visualizer Trục Đùn Mini Prusament cho Sovol SV06 / Plus

Print one of each file. They just snap together without glue.

Please note: depending on the tolerances of your printer, this may be a very, very tight fit onto the motor shaft. I had to scrape mine out a bit with an X-Acto knife before it would fit.

The visualizer does not press all the way into the extruder shaft; please leave a small gap it can still spin freely without rubbing.

This visualizer probably makes for a poor knob. If you need to spin your extruder shaft by hand often, then you'll need to glue all the pieces together so they don't slip when turned manually.