Citrus - Bộ sưu tập đồng xu fidget

This is a collection of a few fidget coins designs. If you want smooth or clicky action, bigger or smaller, you'll find something for you. Descriptions and hardware you'll need is listed below.

These fidget coins require some magnets and a 30mm (17mm inner diameter) thrust bearings. I used these bearings from AliExpress. No link for magnets, as I buy them locally.

Each model has a hex base version if you want to have a better grip on the fidgets and just spin with your thumb. If not, just print two regular halves.

If you want to have that citrus look, print two first layers in beige or white filament. Model designed to be printed at 0.2mm layer height.

The Lemon 🍋

Small smooth action fidget coin. No clicks, just smooth spinning.

Hardware: 

• two 8x3mm round magnets
• thrust bearing

The Lime 

Small clicky fidget coin. Five magnets allow it to make nice quiet clicks.

Hardware: 

• ten 5x2mm round magnets
• thrust bearing

The Orange 🍊

Big smooth fidget coin. Smooth spinning but bigger!

Hardware: 

• two 8x3mm round magnets 
• thrust bearing

The Grapefruit

Big clicky fidget coin. You must see the pattern by now.

Hardware: 

• sixteen 5x1mm round magnets(2mm ones were a bit too strong for smooth operation)
• two 8x3mm round magnets (Alignment purposes. It tended to explode apart when using without them)
• thrust bearing

The Pomelo?

I have some giant 60mm thrust bearings, so there may be a pomelo here some time :)