
Hộp Đựng Thiếc, Flux và Dụng Cụ Gridfinity
Remix of Gridfinity Tái Xây Dựng Bằng OpenSCAD By kennetek
- Downloads
- 71
- Likes
- 12
- Views
- 707
- Remixes
- 1
- Comments
- 0
Files 4 526.4 KB
- gridfinity_solder_holder_1765733740.scadSCAD · 3.4 KB
- standard_1765733741.scadSCAD · 1.9 KB
- gridfinity-rebuilt-utility_1765733742.scadSCAD · 14 KB
- gridfinity_solder_holder_1765733743.stlSTL · 507.2 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #94845
- Category
- DIY
- Published
Description
This is a 2x2 Gridfinity organizer for some of my soldering materials. I use Kester 1lb rolls of solder, which are about 60mm diameter. I found dedicated solder holders are not space efficient, so I wanted a combo organizer. I also like to use a flux pen, which is about 14mm diameter. I made a 16mm hole for the flux. I also made additional holes for small tools, like tweezers. I use this along with other organizers on a 4x4 plate for cutters, water, solder sucker, wick, etc.
I used a ½" dowel rather than print a post.
I used Gridfinity Rebuilt just to generate the base plate and cube. I have yet to fully dig into this openscad project enough to fully understand it. It was useful to get started.
Print spec
- Formats
- scadstl
- Model files
- 4
- Total size
- 526.4 KB
- Largest file
- 507.2 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-

-

-
New


