
Ngôi Sao Cây Thông Noel Siêu Nhân Mario
Remix of Ngôi Sao Cây Thông Noel Hình Mario By PrintinMonkey
- Downloads
- 2,024
- Likes
- 1,401
- Views
- 16,205
- Remixes
- 0
- Comments
- 0
Files 10 5.9 MB
- Christmas_Tree_Super_Star_Shell_0.4n_0.3mm_PETG_MK3S_4h3m_ApproxCost2.68_1766131742.gcodeGCODE · 3.2 MB
- Christmas_Tree_Super_Star_Face_0.4n_0.3mm_PETG_MK3S_2h45m_ApproxCost1.70_1766131743.gcodeGCODE · 1 MB
- Christmas_Tree_Super_Star_4Eyes_0.4n_0.2mm_PETG_MK3S_28m_ApproxCost0.15_1766131744.gcodeGCODE · 445.8 KB
- Christmas_Tree_Super_Star_Shell_1766131737.stlSTL · 55.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #92978
- Category
- Sự Kiện - Lễ Hội
- Published
Description
This is a remix of Printin'Monkey's Mario Christmas Tree Star that allows for easier assembly. I liked the look of his model, but I saw that some of the comments mentioned difficult assembly due to the thin walls. I fully understand the need for a thin wall to let the most light through, but I do not think with my hand-eye coordination limitations I would be able to complete the assembly. I edited the model to increase the edges to make assembly much easier. In fact, now every piece can fit together without the need for glue. These make a great tree topper or a standalone decoration with or without lights on the inside.
For the shell part, I added a bevel to the base of the wall to decrease the likelihood of the walls separating from the face. I also thickened the face from 1mm to 2mm. To eliminate the need for the post part, I thickened the hole on the bottom of the star and made it slightly larger.
For the face part, I added a bevel to the base of the wall to decrease the likelihood of the walls separating. I also increased the wall height to 5mm with four small sections being 10 mm in height to hold the parts together. I also eliminated the walls at the bottom of the star. I added a small groove on a few sides to make separating the two parts easier if I ever need to do that. I also thickened the face from 1mm to 2mm.
For the eyes part, I increased the thickness of the visible portion of the eye to 2 mm. The unseen portion of the eyes are 3 mm in height. Of this, the first 2mm match the depth of the eyeholes on the face and the shell and the last 1mm has a bevel that allows the eyes to be held tightly by the eyeholes. Since the model is still relatively thin, I would recommend supporting both sides of the plastic as you are pushing in the eyes while avoiding putting too much force on the walls.
This remix has the Attribution-NonCommercial license of the original model, and Super Mario Bros. characters are the IP of Nintendo. This file is for non-commercial purposes only.
Print spec
- Formats
- 3mfblendgcodestl
- Model files
- 10
- Total size
- 5.9 MB
- Largest file
- 3.2 MB
0 comments
You may also like 12 models
See all-

-
New -

-
New -

-

-

-

-
New -

-
New -


