Skip to main content
F3D
Giá đỡ Raspberry Pi Camera cho Bambu Lab P1S 1

7 images

Máy In 3D

Giá đỡ Raspberry Pi Camera cho Bambu Lab P1S

By Peter_119713

Downloads
60
Likes
16
Views
1,429

Files 5 1 MB

  • Holder_fix_part_1765722221.stlSTL · 65.6 KB
  • Holder_moving_part_1765722222.stlSTL · 198.4 KB
  • Camera_housing_V3_1765722223.stlSTL · 325.1 KB
  • Camera_housing_V2_1765722224.stlSTL · 278.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#90981
Category
Máy In 3D
Published

Description

I was quite disappointed in the camera quality of my Bambulab P1S and even more in the 0.5FPS.

I had an old Raspberry camera used for my old Prusa MK3 and decided to try it out.

It's not the perfect solution, but it has much better quality and more importantly, 30FPS.

I use a Raspberry Pi 3 with Cam V2 and V3 (wide) and installed the OctoPrint (with new camera stack). The camera is connected via 50cm cable. The Raspberry is housed in a small box and is located behind the AMS.

Because the camera is outside the holder must be movable so I can tilt it upwards to open the door. I used a 20 mm long screw with a diameter of 3 mm to connect the movable and the fixed part.

Print the holder movable part upright with support.

I currently working on version with better cable management. 

After setting up the Octoprint I can use this link to view the stream. http://octopi.local/webcam/webrtc

Remark: You need also a better light. I installed this one: https://www.printables.com/model/365027-bambulab-top-glass-riser-4-cob-led-remix-with-led-

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
1 MB
Largest file
325.1 KB

0 comments

See all