Giá đỡ cần câu cho Radwagon 4 caboose

Dual fishing rod holder for a Radwagon 4 caboose. The caboose has 2 sets of 3 holes for the side rails. This rod holder is designed to fit on any of the holes on either side. If you use the side rails on the caboose you can attach them using the existing screws. If you have a seat or would like to put it in a location without screws, then additional screws and nuts will be required.

I also use some 6-inch ball bungee cords to hold the rod while riding. None of the rods came out without the bungee but they did move around a bit.

Required hardware:

• 1 zip tie

Optional:

• 4 - M6x50 screws
• 4 - M6 lock nuts
• 4 - 6-inch ball bungee cord 

Printer Setting:

• PETG
• .4 nozzle
• .3 layer height
• Printed upside down, added supports for cutout and mounting plate.

Other notes:

I went through a lot of iterations to get the angle and cut out correct. It's pretty good but not perfect. If you have any recommendations or suggestions feel free to comment or remix.