Vỏ Case Meshtastic TTGO T-Beam

This is a rugged case for your Meshtastic TTGO T-Beam device with SMA antenna plug.

I printed this using Overture PETG with 4 outer walls and 25% infil with the Prusament PETG settings. Use a dab of silicon grease on the switch cover for easy operation.

There are two face plate versions, one for the standard and one for a 28mm gps antenna. If you use the standard gps antenna you will need to un-stick it from the back of the T-Beam and move it to the front.

Hardware:

4x M3x12

4x CM2x4 2mm screws

6x M3 4.6x5.7mm heat sink nut inserts

1x 28x28x2.5mm plexi glass square

If you'd like you can buy me a coffee here: https://www.buymeacoffee.com/junrenman