Phần ruột cho Bình Vải Thô

I found that the original vase printed amazingly but as it prints in vase mode it is a bit flimsy due to only having one external wall and an open top. This model creates an internal wall (1mm thick) and a top surface to make it more practical for storing things in.

It's not meant to be printed in vase mode to make it sturdier, but otherwise no special instructions. Just print and glue it onto the rim of the original :)

Note: you'll see that because it prints upside down that my multicolour filament now goes in reverse order so the colours won't 100% match up if you have more than two colours however you could get around this by using PrusaSlicer to chop off the base and print it separately the right way up and then glue that to the tube and then the whole thing to the vase.