
Bản chỉnh sửa Voron Trident RSCS cho máy Trident 300mm
Remix of Quạt hỗ trợ làm mát cho Voron Trident in PLA tốc độ cao By HandsomePotato
- Downloads
- 70
- Likes
- 23
- Views
- 1,431
- Remixes
- 0
- Comments
- 0
Files 6 2.9 MB
- trident_300mm_z_height_1765716652.stlSTL · 200 KB
- trident_300mm_z_height_1765716652.stepSTEP · 219 KB
- saoc_1765716653.stepSTEP · 423.9 KB
- saoc-fan_holder_1765716654.stlSTL · 669.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #89490
- Category
- Máy In 3D
- Published
Description
UPDATE: Because of the stop-switches, I can only turn on the fans after certain height, otherwise, they will blow the bed sideways.
I am not ready to go sensorless but this model has plenty of room to extend if you decide to do so.
I have the LDO Trident 300 ( 300x300x300) and the original design is a little bit too short.
I remixed it to fit my printer specs while allowing adjustments from the original design without crashing with the X/Y endstop.
I am yet to wire and test it but this is out of the scope.
For the sake of practicality and in case the original design gets deleted ( It has happened before with the Mandalorian design I re-uploaded), I am uploading all the untouched files from the original post.
All the credits goes to Mard0
Print spec
- Formats
- stepstl
- Model files
- 6
- Total size
- 2.9 MB
- Largest file
- 1.2 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -
New -

-
New -
New -

-

