Chân kê nâng bàn

My wife wanted her table to be 6 inches higher so she can cut her fabric more easily.  We were using bricks to lift it up but they allowed the table to shift when you leaned against it.  These lifts are more stable and prevent the table from moving around.

The hole for the table foot is 35mm diameter.

Lift is 170 mm tall about the height of 3 bricks stacked with a 8.5% draft.

I printed these in PLA with 10% infill so they could be printed more quickly. The center has a shaft what goes all the way through to help with strength.

Draft angle is higher to allow a larger base and is hollowed out to allow sand or buckshot to be put inside to add weight to the lifter so it is more stable on the floor.

There is also a cap you can glue into the hole to seal in what ever you put in it.

Print with no supports.