Giá Đỡ Cốc Yeti 20oz (Kẹp Mở 23mm)

This is a holder for the Yeti Rambler 20oz Tumbler.

The mounting clip is designed for a board thickness of 23mm. 

Printing Tips

• I used white PLA, 0.4mm nozzle, 0.2mm layers
• Ring:
  • Print top surface on-plate if you prefer that surface finish 
• Mount:
  • Print on its side, so layer-lines are structurally reinforcing for the clip
  • Use 3-perimeters for structure

Assembly Instructions

• There is a small circle-deboss indicating the “bottom” of the ring, as the inner surface is slightly tapered.
• Press-fit the ring into the mount. The pegs should go nearly-flush to the other side.
  • If it's tight, using percussive force didn't seem to harm…