Xí Ngầu Stoli Dodecahedron 12 Mặt

This is an easier to roll Stoli die for the Stoli game created by Bryan Vines (BV3D).

I recommend using 20% infill with the 3D honeycomb pattern.  The problem with 100% infill is that it can cause the corners of the dodecahedron to curl up as the filament cools, which messes up the print.

You need good bed adhesion, my texted PEI plate with PLA filament worked well with no glue or brim as long as I also slowed the print down.

2mm layer height works fine.