Đế lót ly họa tiết dệt đẹp mắt

This woven-look coaster is building on the earlier work of [andrei.erdei] while making some non-trivial changes to the original design.

I've had good success with the following settings:

• 0.3mm layer height
• 3 perimeters
• 100% infill (shouldn't be an issue with 3 perimeters)

No need for brims or supports. I printed the zig-zag pattern on its side to make it easier to remove from the build plate. PrusaSlicer complained about print stability but I think it is a little paranoid and I didn't have any issues over multiple prints.