Kẹp Dây Cáp - Nhanh Gọn & Nhỏ Gọn + Chặt Hơn

The original model was already great design but I wanted to use it for smaller cables and smaller bundles so I made some changes.

• The gap is no smaller so keep smaller cables in.
• 12mm, 16mm and 20mm version (below 12 it gets to small)

With a piece of double sided tape it can be used without screws.

Print instructions:

• PETG (recommended)
• Layer adhesion should be tuned in.
• Layer height of your choice
• NO supports needed

10.12.2023 Warning/Info: I noticed the parts are quite sensitive to getting split when using an electric screw driver. Maybe it is because the parts are from silk PLA which tends to have worse layer adhesion and PLA is brittle in general. I suggest you print in PETG which is less brittle.